- Low viscosity
- Readily mixed and poured
- Excellent release properties
- Good deep section cure
- Hard protective cured rubber
- Good adhesion to primed surfaces
- Not prone to inhibition
|
|
Description
ACC EE RTV 2005 is a readily pourable, white, two component silicone elastomer which cures on addition of the catalyst to a resilient rubber.
Applications
- Potting sensitive components to protect from vibration, high humidity or other harsh environmental conditions
- Protective coating for pcb's
- Protection for automotive electronics, control boxes, etc
- Potting and sealing of cable joint assemblies
| Specifications |
| Uncured Compound |
| Appearance |
Readily pourable liquid |
| Colour |
White |
| Viscosity at 25°C, mPa.s |
Typically 7,000 to 10,000 |
| Active solids content, % |
100 |
Cured Elastomer Results based on a 3mm sheet cured with 1% Curing Agent A after 6 days at 23°C and 65% RH |
| Specific gravity 25°C/25°C |
1.19 |
| Hardness, °IRHD |
45 |
| Tensile strength, Mpa |
>1.4 |
| Elongation, % |
200 |
| Tear strength, kN/m |
8.9 |
| Linear shrinkage, % |
0.5 |
| Peel strength, kg/cm |
0.54 |
| Thermal expansion, cm/cm°C x 10-5 |
25.4 |
| Thermal conductivity, W/m°K |
~0.25 |
Electrical Properties Typical values based on test pieces cured at 25°C for 24 hours using 0.5% Curing Agent A |
| Dielectric strength kV/mm |
20 |
| Volume resistivity, ohm cm x 1015 |
0.5 - 1.0 |
Catalysation and Cure
The recommended concentration of Curing Agent A is between 0.25% and 1% depending on the desired pot life and tack-free time. In general the pot life of ACC EE RTV 2005 catalysed with Curing Agent A will vary from about 3 hours at 0.25% catalyst to about 1 hour at 1%. The rubber will cure in approximately 24 hours to a hardness of approximately 40 °IRHD (measured on a test piece 12mm thick).
Additional printed catalogue or brochure available
Obtain more information, samples or literature
Contact details and how to order
|